Leveling Legs; Removal Of Gas Appliance - Jenn-Air DUAL-FUEL DOUBLE OVEN RANGE Use & Care Manual

M
AINTENANCE

Leveling Legs

CAUTION
Be sure the anti-tip bracket secures one of the rear
leveling legs to the floor. This bracket prevents the range
from accidentally tipping.
The range should be leveled when installed. If
the range is not level, turn the leveling legs,
located at each corner of the range, until
range is level.
Convenience Outlet
(Canadian models only)
The convenience outlet is located on the lower left side of the
backguard. Be sure appliance cords do not rest on or near the
surface element. If the surface element is turned on, the cord
and outlet will be damaged.
The convenience outlet circuit breaker
may trip if the small appliance plugged
into it exceeds 10 amps. To reset the
circuit breaker, press the switch
located on the lower edge of the
backguard.

Removal of Gas Appliance

Gas appliance connectors used to connect this appliance to
the gas supply are not designed for continuous movement.
Once installed, DO NOT repeatedly move this gas appliance
for cleaning or to relocate. If this appliance has to be moved
and/or removed for servicing, follow the procedure described
in the installation instructions. For information, contact Jenn-
Air Customer Service at 1-800-JENNAIR (1-800-536-6247).
To prevent range from accidentally tipping, range must be
secured to the floor by sliding rear leveling leg into the anti-
tip bracket.
ANTI-TIP BRACKET ANTI-TIP BRACKET
LEVELING LEG
LEVELING LEG
CIRCUIT BREAKER
24