Samsung HW-C900 User Manual page 45

SEITING THE TEST TONE
•
•
C J)
m
"'0
en.! TeS'
L.lij . LJ.
2) Press the A T buttons to set the Test Tone mode you want.
You can adjust the speaker output level from -10 to +1OdB by 1 step.
The sound gets quieter at -1 OdB and louder at
+
1OdB.
Use the test tone to check the speaker connection status or level.
1. Press the SETUP/MENU button on the remote control.
• Each time the button is pressed, the mode switches between SETUP
ENTER and SETUP OFF.
2. Press the ENTER button to select SETUP ENTER.
3. Press the A T buttons to select TEST TONE, and then press the ENTER
or ~ button.
4. Press the A T buttons to select the option you want, and then press the
ENTER or ~ button.
• AUTO : Test signal will be automatically output as follows; F. L ~ CEN ~
SW ~ F.R ~ S.R ~ SBR ~ SBL ~ S.L.
- During test tone output, press the .... buttons to adjust the speaker
output level from -10 to + 10 dB by 1 step.
• MANUAL: Enables you to adjust the output level of the speaker
manually.
1) Press the ENTER or
~
button to select the speaker you want.
Each time you press the ENTER button, F.L ~ CEN ~ SW ~ F.R ~ S.R ~ SBR ~ SBL ~ S.L will be
selected in turn.
- Test Tone Output -
• F.L (front left) : -10 - + 1OdB
• F.R (front right) : -10 - + 1OdB
• S L (surround left) : -10 - + 1OdB
• S.R (surround right) : -10 - + 1OdB
• CEN (center) : -10 - + 1OdB
• SW (subwoofer) : -10 - + 1OdB
• SBL (surround back left) : -10 - + 1OdB
• SBR (surround back right) : -1 0 - + 1OdB
- To stop test tone -
• Press the SETUPIMENU button once.
SETUP OFF appears on the display and test tone stops.
(EJ •
In the Dolby Pro Logic liz mode, test signal will be automatically output as follows: F.L
~
FHL
~
CEN
~
SW ~ FHR ~ F.R ~ S.R ~ S.L.
45