Checking Arm/Disarm; Testing Disarming Without A Remote; Testing Ignition Trigger; Testing The Pin Protection Switch(Es) - Viper 480XV Installation Manual

Certificate of Installation
After installation you must fill out the certificate of installation. Once you have filled out all infor-
mation on the certificate the customer must sign and date it. Distribute the copies as follows:
➤ ➤
White (top) copy - customer
➤ ➤ Blue copy - customer's insurance broker
➤ ➤
Pink copy - Directed Electronics, UK office
➤ ➤
Green copy - installing dealer
Troubleshooting and System Testing

Checking arm/disarm.

Use the and
➤
Repeat both tests at required distance to test range.
➤

Testing disarming without a remote

1. Arm the alarm or let the system AutoImmobilise.
2. Turn the ignition On.
3. Enter the preset PIN code as described in the Programming Instructions section.
4. If the correct code was entered you should hear two chirps and the system should disarm.

Testing Ignition Trigger

Arm alarm.
➤
Turn ignition on, alarm should trigger after the progressive chirp sequence.
➤
Disarm alarm.
➤

Testing the Pin protection switch(es)

Arm the alarm system.
➤
Open the boot or bonnet or doors in turn to make sure all perimeter protection switches
➤
operate.
The alarm should trigger. Adjust Pin switch if required.
➤
48
buttons on both remote controls to arm and disarm the alarm.
© 2005
Directed Electronics, Inc. all rights reserved