Bypassing Sensor Inputs; System Features Learn Routine - Viper 480XV Installation Manual

Bypassing Sensor Inputs

There are times when you need to temporarily bypass all sensor inputs to the unit, such as when
activating the windows or leaving a person or pet inside the vehicle. Anytime an auxiliary channel
output is used, sensor inputs are bypassed until 5-seconds after the output turns off.
To temporarily disable a sensor input, arm
system will respond with 3 indicator flashes. This means all sensor warn-away triggers are bypassed.
Press the button again and the system will respond with 4 indicator light flashes. This means all
sensor warn-away and full triggers are bypassed.

System Features Learn Routine

The System Features Learn Routine allows the unit to be customised to the vehicle and user's
requirements. Due to the number of steps, they have been broken up into three menus. It is possible
to access and change any of the feature settings using the Valet/Program button. However, this
process can be greatly simplified by using the 998T Bitwriter
and then assigned to a particular transmitter, up to four, a feature called Owner Recognition. Each
time that particular transmitter is used to disarm the system, the assigned feature settings will be
recalled. Owner Recognition is only possible when programming the unit via the 998T Bitwriter
If the system was previously programmed using the 998T Bitwriter
locked. If the siren generates one long chirp when attempting to program the unit, the learn routine
is locked and must be unlocked using the 998T Bitwriter
1. O O p p e e n n a a d d o o o o r r . . (The H1/3 GREEN wire or the H1/5 VIOLET wire must be
connected.)
2. I I g g n n i i t t i i o o n n . . Turn the ignition on, then back off.
3. S S e e l l e e c c t t a a M M e e n n u u . . Press and HOLD the Valet/Program button: (The
Valet/Program button must be plugged into the blue port.) After three seconds
the siren will chirp once and the LED will flash once indicating entry to the
Basic Features Menu #1. If this is the menu you wish to access, release the
button and go on to Step 4. If the button is not released, you will jump to the
2005
©
Directed Electronics, Inc. all rights reserved
the system. Press the
. Any of the settings can be changed
®
, the learn routine may be
®
.
®
button again and the
.
®
29