The System Will Not Arm Or Disarm; The Valet Switch Does Not Work; The Status Led Does Not Work; Closing The Door Triggers The System, But Opening The Door Does Not - Viper 480XV Installation Manual

The system will not arm or disarm

Make sure the ignition is not turned on or that the ignition input wire does not have 12volts.
➤
Make sure the systems 15 amp main fuse has been installed or is not blown.
➤
Make sure the external receiver has been plugged into the main control module correctly.
➤

The Valet switch does not work

Make sure that it is plugged in. (See the Plug-In Harness section of this guide.)
➤
Check the System Features Learn Routine for the default PIN code.
➤
Has the PIN code been changed?
➤

The status LED does not work

Make sure that it is plugged in. (See the Plug-In Harness section of this guide.)
➤

Closing the door triggers the system, but opening the door does not.

Have you correctly identified the type of door switch system? This happens often when the
➤
wrong door input has been used.
System will not passively arm until it is remotely armed and then
disarmed
Are the door inputs connected? Is a BLUE H1/4 wire connected to the door trigger wire in the
➤
vehicle? Either the GREEN H1/3 or the VIOLET H1/5 should be used instead.
2005
©
Directed Electronics, Inc. all rights reserved
49