Autopage C3-RS-1000 OLED Operation Manual page 5

SVMASTER -
OLED Display
Button
Button
Button
Button
Reset Hole
B. CHARGE THE BATTERY
The unit has a built-in 3.7V lithium polymer battery. If the OLED
screen dis play low battery or the
transceiver needs charging. Please use the included AC / USB
charger to charge the battery. While the battery is charging, you can
push the " " button to check charging condition. The battery should
be charged at least once a month under normal operation.
XT-90S: This transmitter uses one (1) 3 -volt lithium ion battery (#CR2032) that is placed with the (+) side facing
upward. To replace the battery, you will need to use a small flat blade screwdriver and a small Philips screwdriver.
Remove the small Philips head screw. Then locate the small notch on the lower right side of the transmitter case next
to the key ring. Using the flat blade screwdriver, carefully pry the top case from the bottom case. It should snap
apart after breaking the seal. Before removing the battery note the direction of the positive (+) terminal. Place the
new battery in exactly the same manner, being careful not to bend or damage the contact terminal. Snap the cases
back together and then test the transmitter to insure it arms and disarms the alarm. Reinstall the Philips screw to
finalize the battery replacement.
XT-90S Extended Range Sliding Cover remote
SVMASTER -
C3RS1000 OP 3/08
Antenna Antenna
1
3
icon is flashing, your remote
switch switch
button button
switch switch
Button
Button 2
Button
Button 4
5
http://www.msvmaster.lv
-
http://www.msvmaster.lv
-