Table of Contents
Advertisement
SVMASTER -
remote.
F. PASSIVE ARMING (Programming Required)
Active arming / disarming is controlling your security system via the remote transmitter. This security system
is equipped with an optional Passive Arming feature which allows the security system to arm 30 seconds
after the last door is closed. Operation is as follows.
1. Turn the ignition to the "OFF" position and exit the vehicle.
2. After all entrances are closed, the security system LED will flash fast for 30 seconds. If you reopen any
door / hood / trunk, the security system LED will stop flashing. It will begin flashing again once all of the
vehicle entrances are closed.
3. After 30-second timer has elapsed, the security system will automatically "ARM". The siren will chirp [1]
time and the parking lights will flash [1] time.
PASSIVE ARMING WITH PASSIVE DOOR LOCKING :
The vehicle doors will automatically lock after passive arming cycle has been completed.
PASSIVE ARMING BY-PASS: While the system disarmed, Press the
with [1] chirp and LED will turn "ON". The security syste m will remain in this temporary state for as long as you
wish. To exit passive by-pass, press the transmitter
G. ACTIVE DISARMING – UNLOCK & DISARM:
1. Press
button on the transmitter.
2. The siren will chirp twice and parking light flash twice to indicating that the security system is now disarmed.
The vehicle's door will unlock and dome light turns on for 30 seconds upon disarming when interfaced with
the security system.
TAMPER DISARMING: If alarm triggered, upon disarming the system, the siren will chirp 4 times and the
parking light will flash 3 times.
PATHWAY ILLUMINATION: This feature turns the parking lights "ON" for 30 seconds upon an unlock
signal and for 10 seconds upon the lock signal. (Programming required)
TWO STEPS DOOR UNLOCK: This feature will independently unlock the driver's door only when disarming
the security system. Pushing the
(Additional installation is required)
AUTOMATIC RE-ARM: If this feature is selected, the security system will automatically re-arm itself in 60
seconds after disarming with remote transmitter. Automatic rearm will cancel if the ignition is turned ON
and will pause if any door is opened before the 60 seconds timer has elapsed.
H. DISARMING WITHOUT A TRANSMITTER
OVERRIDES THE ALARM WITHOUT PASSWORD PIN CODE: (Factory Default Setting)
The Override function may be used if the remote transmitter is lost or inoperative.
1. Enter the vehicle and turn the ignition switch to 'ON' position. (Alarm will sound.)
2. Within 10 seconds push and release the valet switch
The alarm will stop sounding and enter the disarmed mode. You can now start and operate the vehicle
normally.
OVERRIDE THE ALARM WITH PASSWORD PIN CODE:
If the valet switch is located in a place that can be easily found, this security system allows the consumer to
program a password pin code offering a higher level of security.
1. Enter the vehicle and turn the ignition switch to the 'ON' position. (Alarm will sound.)
2. Within 5 seconds, enter your chosen the first digit code by pressing and releasing the Valet Switch.
SVMASTER -
C3RS1000 OP 3/08
or
button and the system will return to normal status.
SILENT DISARMING: Spin up the
then press the "Silent Disarm" button or press the transmitter
and
buttons at the same time to disarm your security
system, No chirp sound will be heard, arm and disarm
confirmation will be through the vehicles parking lights only.
button a second time within 3 seconds will unlock the other doors.
15
http://www.msvmaster.lv
-
button twice, the security will respond
switch to the page
http://www.msvmaster.lv
-
and
1
Advertisement
Table of Contents
