Table of Contents
Advertisement
Group ID (2 - 4094): Enter a number according to the permitted range.
o
Setting value "0" deletes the VLAN group ID. If this is done while the
VLAN Group is enabled, the group gets disabled and the group ID is
deleted.
Enable DHCP: Enables/disables DHCP for the selected VLAN group.
o
IP Address: Accept the default setting or set the IP address for the
o
selected VLAN group.
Network Mask: Accept the default setting or set the network mask for
o
the selected VLAN group.
Apply: Click the "Apply" button to activate the settings.
o
IP Filter
The MMB enables the user to configure up to 10 valid host IP addresses/subnets for
each protocol (HTTP/HTTPS, SSH, SNMP and Telnet). The default value permitting
any IP address is 255.255.255.255.
0.0.0.0 inhibits a protocol. An exact address like 1.2.3.4 enables only this IP address.
Further 3 groups of ranges can be defined (nn.255.255.255 / nn.nn.255.255 /
nn.nn.nn.255).
Protocols Permitted Globally: Selects the globally permissible protocol type (if
•
enabled, one of 10 filter addresses/subnets for this protocol is set to default
value 255.255.255.255; if disabled, the value is set to 0.0.0.0).
IP Filter List: Here the IP filter settings are listed. They are only active if global
•
permission is disabled.
New IP Filter: Here you can specify a permissible protocol and an IP address or
•
a range of IP addresses in the form of a subnetwork mask which may access the
MMB.
For example, if the host has an IP address 10.10.10.80, then the following IP
filters are possible, i.e. reasonable:
1. IP filter 10.255.255.255: any host IP with 10.xx.xx.xx.
2. IP filter 10.10.255.255: any host IP with 10.10.xx.xx.
3. IP filter 10.10.10.255: any host IP with 10.10.10.xx.
4. IP filter 10.10.10.80: only host IP with 10.10.10.80.
AuDi-MIP
Basic
Basic Configuration
•
Enable AuDi-MIP: Enables/disables the automatic distribution of
o
management IP addresses.
AuDi-MIP Configuration
o
All / Detailed: Select "All" for including the server blades and the
connection blades in one IP address range together with the
master management blade. Select "Detailed" if you want to
specify separate IP address ranges for server blades and for
connection blades.
IP Address Range: Enter the first address and the last address of
the address range.
Settings
31
Advertisement
Table of Contents
