Table of Contents
Advertisement
Components
the here defined name.
The connection blade takes the assigned name and uses it (if it was not
overwritten) for the following system settings:
1.) Prompt name in the connection blade's built-in command line interface
2.) Port naming
3.) Host name
FC Domain Settings: The user can find and configure the setting Domain ID for
•
the FC connection blade. When setting the FC connection blade, it needs to
disable itself temporarily, and the complete configuration will be cleared when
the connection blade is disabled. The setting value should be fffcxx. xx is a
hexadecimal value and the validate values range from 1 to 239.
Management Port Control: This setting permits the management port (network
•
interface for managing the connection blade) to be switched between the
positions "external/Front" and "internal/MMB1 or MMB2".
Management Port Settings: Displays the connection blade's network setting
•
information.
Enable DHCP: Sets the IP mode (DHCP or NO-DHCP) for the
o
management IP settings of the connection blade.
IP Address / Subnet Mask / Gateway Address: Displays the connection
o
blade's management IP address / subnet mask / gateway address.
Current Value: The IP address / subnet mask / gateway address [Current
o
Value] is the current connection blade management IP address / subnet
mask / gateway address.
Reset Interface Settings to Default: Resets the interface settings listed below to
•
their default values:
User Assigned Name: [<rack name>-]<enclosure name><last 6 digits of
o
enclosure serial no.>-CB<bay no.>
As default the <rack name> is empty.
DHCP OOB: enabled
o
Internal Stacking Link: disabled
o
Management Port Select (8Gb FC Connection Blade-x): Depending on
o
which port the MMB is inserted "00" or "01" is displayed.
Firmware Mode Settings: Some connection blades are able to boot different
•
firmware modes. Changing the boot mode forces a reboot of the connection
blade. Please refer to the corresponding connection blade manual for the
detailed information about boot modes.
Account Settings
•
Privileged Mode Password: Enter a password for the privileged mode of
o
the connection blade.
Login User Name: Enter the login user name for the connection blade's
o
web home page.
Login Password: Enter the login password for connection blade's web
o
home page.
Note: If the preconfigured user and password settings are changed via the
connection blade's command line interface or WebUI, these login settings have
16
Advertisement
Table of Contents
