Fujitsu PRIMERGY B900 Reference Manual page 13

Firmware Mode: Displays the firmware mode. The blade types "10GbE
o
Connection Blade-x" and "GbE Connection Blade-x" can have the
values "Switch" or "IBP".
The mode can be set via the connection blade's built-in command line
interface or via the "Configuration" tab, "Firmware Mode Settings".
Afterwards the blade has to be rebooted or reboots automatically.
Stacking Status: For connection blades with the product name
o
"Connection Blade GbE 36/8+2" only. Displays the stacking status
("Master" or "Member").
Management Port MAC Address: Displays the MAC address of the
o
connection blade's management port.
Administrative URL: URL to link the connection blade's web home
o
page.
Power Management
Power Settings: The user can reset the blade after selecting the power action and
•
clicking the "Apply" button.
Configuration
The current status of some parameters is queried using the "Refresh" button. This is
necessary as the parameters can also be changed via the connection blade's own
management functions. If no change is displayed after the button has been pressed, this
means that the parameter has not been changed by the connection blade up to this point
in time.
User Assigned Name: Enter the connection blade's user assigned name.
•
The user assigned name may not be longer than 31 characters and must start
with a letter that can be followed by letters, digits, underscores ("_"), and
hyphens ("-"). Changing the rack name (via the menu item "System Unit" in the
Web UI) may overwrite the here defined name (affects the types "GbE
Connection Blade-x" and "10GbE Connection Blade-x" only).
The connection blade takes the assigned name and uses it (if it was not
overwritten) for the following system settings:
1.) Prompt name in the connection blade's built-in command line interface
2.) Port naming
3.) Host name
4.) DHCP client identifier
Management Port Settings: Displays the connection blade's network setting
•
information.
Enable DHCP: Sets the IP mode (DHCP or NO-DHCP) for the
o
management IP settings of the connection blade.
DHCP Client Name: Set the DHCP client name for the connection blade.
o
It is only valid when DHCP is enabled.
IP Address / Subnet Mask / Gateway Address: Displays the connection
o
blade's management IP address / subnet mask / gateway address.
Untagged VLAN: Default value is "untagged".
o
VLAN ID: Sets the VLAN ID.
o
Stacking Port Setting: Enables/disables the internal stacking port (only in the
•
case of connection blades with the product name "Connection Blade GbE
Components
13