Configuring Radius - Cisco ISR Configuration Manual

Configuring and Enabling RADIUS

Configuring RADIUS

This section describes how to configure your access point to support RADIUS. At a minimum, you must
identify the host or hosts that run the RADIUS server software and define the method lists for RADIUS
authentication. You can optionally define method lists for RADIUS authorization and accounting.
A method list defines the sequence and methods to be used to authenticate, to authorize, or to keep
accounts on a user. You can use method lists to designate one or more security protocols to be used, thus
ensuring a backup system if the initial method fails. The software uses the first method listed to
authenticate, to authorize, or to keep accounts on users; if that method does not respond, the software
selects the next method in the list. This process continues until there is successful communication with
a listed method or the method list is exhausted.
You should have access to and should configure a RADIUS server before configuring RADIUS features
on your access point.
This section contains this configuration information:
•
•
•
•
•
•
•
•
•
•
•
The RADIUS server CLI commands are disabled until you enter the aaa new-model command.
Note
Default RADIUS Configuration
RADIUS and AAA are disabled by default.
To prevent a lapse in security, you cannot configure RADIUS through a network management
application. When enabled, RADIUS can authenticate users accessing the access point through the CLI.
Cisco Wireless ISR and HWIC Access Point Configuration Guide
7-4
Default RADIUS Configuration, page 7-4
Identifying the RADIUS Server Host, page 7-5
Configuring RADIUS Login Authentication, page 7-7
Defining AAA Server Groups, page 7-9
Configuring RADIUS Authorization for User Privileged Access and Network Services, page 7-11
(optional)
Starting RADIUS Accounting, page 7-12
Selecting the CSID Format, page 7-13
Configuring Settings for All RADIUS Servers, page 7-13
Configuring the Access Point to Use Vendor-Specific RADIUS Attributes, page 7-14
Configuring the Access Point for Vendor-Proprietary RADIUS Server Communication, page 7-15
(optional)
Configuring WISPr RADIUS Attributes, page 7-16
Chapter 7
(required)
(required)
(optional)
(optional)
(optional)
(optional)
(optional)
Configuring RADIUS Servers
(optional)
OL-6415-04