Configuring Mac Authentication On The Radius Server; Bridge - Cisco WAP571 Administration Manual

Wireless

Bridge

STEP 3
STEP 4
NOTE
NOTE
Bridge
Cisco WAP571/E Administration Guide
The filter setting also applies to the MAC filtering list stored on the RADIUS
NOTE
server, if one exists.
In the MAC Address field, enter the MAC address to allow or block and click Add.
The MAC address appears in the Stations List.
Continue entering MAC addresses until the list is complete, and then click Save.
The changes are saved to the Startup Configuration.
To remove a MAC address from the Stations List, select it and then click Remove.
After new settings are saved, the corresponding processes may be stopped and
restarted. When this happens, the WAP device may lose connectivity. We
recommend that you change WAP device settings when a loss of connectivity will
least affect your wireless clients.

Configuring MAC Authentication on the RADIUS Server

If one or more VAPs are configured to use a MAC filter stored on a RADIUS
authentication server, you must configure the station list on the RADIUS server. The
format for the list is described in this table:
RADIUS Server
Attribute
User-Name (1)
User-Password (2)
This section describes the two types of bridges. It includes the following topics:
WDS Bridge
Description
MAC address of the client station.
A fixed global password used to
look up a client MAC entry.
5
Value
Valid Ethernet MAC
address.
NOPASSWORD
102