Auxiliary Harness (H3) Wire Connection Guide - Avital 3300L Installation Manual

auxiliary harness (H3) wire connection guide

______
H3/1
______
H3/2
______
H3/3
H3/1 VIOLET BLACK (-) 200mA channel 4 output
This wire supplies a (-)200mA output whenever the button(s) controlling channel four is pressed and will con-
tinue until the button(s) is released. This output can be used to control optional accessories.
IMPORTANT! Never use this wire to drive anything but a relay or a low-current input! This
transistorized output can only supply (-)200 mA, and connecting directly to a solenoid, motor, or
other high-current device will cause the module to fail.
NOTE: Many of the options that can be operated with this output require the addition of the relay
accessory package (p/n 8617).
H3/2 BROWN/BLACK (-) 200mA horn honk output
This wire supplies a (-) 200 mA output that can be used to honk the vehicle's horn. It provides a single pulse
when armed and two pulses when disarmed. This wire also provides pulsed output when the security system is
in the triggered sequence or in panic mode. In most vehicle's with (-) horn circuits this wire can control the
vehicle's horn without adding a relay.
NOTE: If this output is used to drive a (+) horn circuit, an optional standard automotive SPDT relay
or a relay assembly package (p/n 8617) must be used. See the following diagram.
20
VIOLET/BLACK
BROWN/BLACK
BLUE
(-) 200 mA CHANNEL 4 OUTPUT
(-) 200 mA HORN HONK OUTPUT
(-) 200 mA SECOND UNLOCK
2008 Directed Electronics, Vista CA - all rights reserved