JVC HX-Z1 Service Manual page 7

Compact component system

Hide thumbs Also See for HX-Z1:

Table of Contents

Enlarged version

2.1.3 Removing the front panel assembly

(See Fig.6 ~ 9)

• Prior to performing the following procedure, remove the metal

cover and the CD changer mechanism assembly.

(1) Disconnect the card wire from connector CN44 and

CN870 on the main board on the right side of the body.

Remove the screw D attaching the wire from extending

from the underside of the front panel assembly.

(2) Disconnect the wire from connector CN701 on the bridge

board.

(3) Cut the tie band.

(4) Disconnect the wire from connector CN231 and CN232 on

the primary board on the left side of the body and remove

the band fixing the wire.

(5) Remove the plastic rivet attaching the inner bar in the cen-

ter of the front panel assembly.

REFERENCE:

Keep the plastic rivet for reuse.

(6) Remove the three screws E attaching the front panel as-

sembly at the bottom of the body.

(7) Release the two joints a on the lower left and right sides of

the front panel assembly using a screwdriver, and remove

the front panel assembly toward the front.

REFERENCE:

Front panel need to be tilt a little bit as release from bot-

tom chassis.

HX-Z1

Fig.6

Fig.7

Fig.8

Fig.9

Table of Contents