JVC HX-Z1 Service Manual page 11

Compact component system

Hide thumbs Also See for HX-Z1:

Table of Contents

Enlarged version

2.1.8 Removing the bridge board / regulator board / heat

sink (See Fig.21 ~ 27)

• Prior to performing the following procedure, remove the metal

cover, the CD changer mechanism assembly, the rear panel,

the antenna board and main board.

(1) Remove the plastic rivet attaching the stay inner bar and

remove the screw H on the bridge board.

(2) Move the inner bar forward and upward to release from the

front section (joint f) and from the bridge board (two joints

h) respectively.

(3) Remove the two plastic rivets setting the holding board fix-

ing the bridge board and the primary board. Move the

bracket board in the direction of the arrow.

(4) Disconnect the wire from connector CN212, CN213 and

CN214 on the primary board respectively and remove the

band attaching the wires.

(5) Disconnect the wire from connector CN701 on the bridge

board.

Fig.21

Fig.22

Fig.23

HX-Z1

Fig.24

Fig.25

Table of Contents