JVC HX-Z1 Service Manual page 14

HX-Z1
2.2.3 Removing the display system control board
(See Fig.31, 32)
(1) Remove the four screws S attaching the stay bracket (1).
(2) Disconnect the card wire from connector CN43 and
CN880 on the display system control board.
Remove the ten screws T attaching the display system
control board.
2.2.4 Removing the bottom board
(See Fig.33 ~ 35)
• Prior to performing the following procedure, remove the dis-
play system control board.
(1) Pull out preset knob, sound mode knob on the front panel
toward the front.
(2) Remove the nut at volume knob encoder from front panel.
(3) Remove the four screws U attaching the stay bracket (2).
(4) Remove the eight screws V attaching the bottom board.
Fig.33
14
Fig.31
Fig.32
Fig.34
Fig.35