JVC HX-Z1 Service Manual page 24

Compact component system

Hide thumbs Also See for HX-Z1:

Table of Contents

Enlarged version

HX-Z1

3.2.3 Removing the head amplifier & mechanism control

board (See Fig. 4)

(1) Remove the cassette mechanism assembly.

(2) After turning over th cassette mechanism assembly, re-

move the three screws A retaining the head amplifier &

mechanism control board.

(3) Disconnect the connector CN32 on the board including the

connector CN1 on the reel pulse P.C. board.

(4) When necessary, remove the 4 pin parallel wire soldered

to the main motor.

3.2.4 Removing the main motor assembly

(See Fig.4 ~ 7)

(1) Remove the two screws B retaining the main motor as-

sembly (See Fig. 4 and 5).

(2) While raising the main motor, remove the capstan belt

from the motor pulley (See Fig. 5).

CAUTION:

Be sure to handle the capstan belt so carefully that this belt

will not be stained by grease and other foreign matter. More-

over, this belt should be hanged while referring to the capstan

belt hanging method in Fig. 6 and 7.

Fig.4

Fig.5

Fig.6

Fig.7

Table of Contents