Handlebar Assembly - Smooth Fitness VT-3.4 Owner's Manual

"A
I
SSEMBLY NSTRUCTIONS"
a. Remove the 4pcs Washers (8x16x2.0t)(80), 4pcs Lock Washers (M8)(79) and 4pcs
Bolts (M8xp1.25x16mm)(102) from the Fixed Handlebar (7).
b. Insert the Fixed Handlebar (7) (as pictured above) through the Upright Post
Assembly (6) and secure it with the 5pcs Washers (8x16x2.0t)(80), 5pcs Lock Washers (M8)(79) and 4pcs Bolts
(M8xp1.25x16mm)(102)and 1pcs Bolt (M8xp1.25x45mm)(100) NOTE: The additional 1pc Washer (8x16x2.0t)(80),
1pc Lock Washer (M8)(79), 1pc Bolt (M8xp1.25x45mm)(100) will be packed into HARDWARE KIT
S –
TEP 11 Console and Data Cable Assembly
a. Refer to FIG.4 to attach the Console Bottom Sleeve (33) to the Console (32) and secure it with the 4pcs Bolts
(M5xp0.8x25mm)(90).
b. Place and secure the Console Assembly (32, 33) onto the console base plate on the Upright Post Assembly (6) by
using the 4pcs Bolts (M6xp1.0x15mm)(98).
c. Connect the Upper Data Cable (117) to the Middle Data Cable (118). Be care not to pinch the wires
d. Connect the Front Pulse Sensor Wire (124) to the Rear Pulse Sensor Wire (125). Be care not to pinch the wires
FIG.4
10
S –
TEP 9 Handrail Base
Cover Assembly
To assemble the Handrail Base Cover
(128, 129), place the Left Handrail
Base Cover (128) on the inner side of
the Right Middle Handlebar (11).
Place the Right Handrail Base Cover
(129) at the outer side of the Right
Middle Handlebar (11). Bolt the
Handrail Base Covers (128, 129) with
the 2pcs Flat Head Self-Tapping
Screws (M4x16mm)(88). Repeat the
process above for the left side.
S –
TEP 10 Fixed

Handlebar Assembly

NOTE: The 4pcs Washers
(8x16x2.0t)(80), 4pcs Lock Washers
(M8)(79) and 4pcs Bolts
(M8xp1.25x16mm)(102) have been
preinstalled on the left and right sides
of the Fixed Handlebar (7).
B.