Type 8316
To remove the system board, do the following:
1. Turn off the computer and peripheral devices and disconnect all external cables
2. Disconnect all cables connected to the system board.
3. Remove the screws that secure the system board to the chassis and lift out the
4. Remove the DIMMs from the system board. Refer to "Replacing memory (all
5. Remove the microprocessor from the system board. Refer to "Replacing a
To replace the system board, do the following:
1. Install the microprocessor on the new system board. Refer to "Replacing a
2. Install the DIMMs on the new system board. Refer to "Replacing memory (all
3. Place the new the system board into the chassis and install the screws that
4. Reconnect all cables that connect to the system board. Refer to "Identifying
5. Go to "Replacing the cover and connecting the cables."
Replacing the cover and connecting the cables
Types 2296 and 8434
After replacing FRUs, you need to install any removed parts, replace the cover, and
reconnect any cables, including telephone lines and power cords. Also, depending
on the FRU that is replaced, you might need to confirm the updated information in
the IBM Setup Utility program.
64
Hardware Maintenance Manual
and power cords; then, remove the cover. See "Removing the cover" on page
32.
system board.
machine types)" on page 40.
microprocessor (all machine types)" on page 61.
microprocessor (all machine types)" on page 61.
machine types)" on page 40.
secure the system board to the chassis.
parts on the system board (all machine types)" on page 40.