IBM ThinkCentre 2296 Hardware Maintenance Manual page 56

Removing a drive
1. Remove the cover. See "Removing the cover" on page 32.
2. Pivot the drive-bay latch handle toward the front of the computer and then
3. Disconnect the signal cable and power supply cable from the drive being
4. Remove any screws that secure the drive. Not all drives have screws.
Installing a drive
1. Make sure the drive that you are installing is set correctly as either a master or
50
Hardware Maintenance Manual
pivot the appropriate drive-bay cage upward, as shown, until latched in the
upright position.
Notes:
a. Both drive-bay cages pivot in the same manner.
b. You can lift the drive-bay cages out of the chassis to make it easier to
remove and install the drives.
c. Take note of the location of any cables you disconnect. You might have to
disconnect cables to other drives to gain access to the drive you are
removing.
replaced.
a slave device. Jumper the new drive the same as the drive being replaced.