Types 8198 And 8199 - IBM ThinkCentre 2296 Hardware Maintenance Manual

Refer to the documentation that comes with your drive for master/slave
jumper information.
2. Install the drive into the bay as shown.
3. Secure the new drive (if necessary) with the screws that were removed.
4. If necessary, place the drive-bay cages back into the chassis.
5. Continue at "Connecting the drive" on page 56.

Types 8198 and 8199

Drive bay information
Any bay that does not have a drive installed has a static shield and bay panel
installed.
The following illustration shows the locations of the drive bays.
Chapter 6. Replacing FRUs
51