Note: Take note of the location of any cables you disconnect. You might have
to disconnect cables to other drives to gain access to the drive you are
removing.
4. For the hard disk drive, you can lift the tray out of the computer.
5. Remove any screws that secure the drive. Not all drives have screws.
Installing a drive
1. Make sure the drive that you are installing is set correctly as either a master or
a slave device. Jumper the new drive the same as the drive being replaced.
Refer to the documentation that comes with your drive for master/slave
jumper information.
2. Install the drive into the bay and secure with any screws that were removed.
This illustration shows the hard disk drive installation.
3. Pivot the drive-bay cage back into place.
4. Continue at "Connecting the drive" on page 56.
Chapter 6. Replacing FRUs
55