Type 8191 - IBM ThinkCentre 2296 Hardware Maintenance Manual

2. Install the drive into the bay. Align the screw holes and install two screws to
secure the drive.
Note: This illustration shows a CD drive installation. The hard disk drive and
diskette drive is installed in the same manner except that the front bezel
is not in place.
3. If the front bezel was removed, replace it by aligning the four plastic tabs and
pressing the bezel into position.
4. Go to "Connecting the drive" on page 56.

Type 8191

Drive bay information
Any bay that does not have a drive installed has a static shield and bay panel
installed.
The following illustration shows the locations of the drive bays.
The following table describes the drive height limitation for each drive bay.
Bay 1 and Bay 2 - Maximum height: 43.0 mm (1.7 in.)
Bay 3 and Bay 4 - Maximum height: 25.8 mm (1.0 in.)
Chapter 6. Replacing FRUs
49