Table of Contents
Advertisement
6.5.11 Cumulative power monitor (1kWh increments) (network output
SNVT_elec_kwh nvoDrvRunPower)
You can monitor the cumulative power of the inverter in 1kWh increments.
You can select monitoring data from either BCD code data or binary data according to Pr. 170 Watt-hour
meter clear. The initial value is binary data. (For details of Pr. 170, refer to the inverter manual.)
Data Name
nvoDrvRunPower
*1
The digit of monitoring data shifts according to the Pr. 891 setting. Refer to the inverter manual (applied) for details of Pr. 891.
REMARKS
When the numerical value exceeds the maximum value in the monitoring range, the value returns to 0 and is
recounted from 0.
⋅ Data send event ...................... When data changes in 1kWh increments.
⋅ Data send timing ..................... As set in Pr. 388 Heartbeat send time interval and Pr. 389 Minimum heartbeat
6.5.12 Alarm reset (network input SNVT_switch nviInvAlarmReset)
You can reset the inverter at inverter alarm occurrence.
Data Name
nviInvAlarmReset
⋅ Data acceptance timing....... When network variables are being received and state = 1 (nv_update_occurs event)
REMARKS
You can reset the inverter at inverter alarm occurrence. When the inverter is not during an alarm, performing this
operation does not reset the inverter.
Initial Value
Pr. 170
10
0kWh
9999
(initial value)
send time. (Refer to page 75)
Initial
Range
Value
state
H0
Don't care
H0
H1
(not used)
H2 to HFF
Range
0 to 9999kWh (BCD code data)
0 to 65535kWh (binary data)
value
Without alarm reset
Execute an alarm reset.
Invalid
NETWORK VARIABLES
Increments
1kWh/bit
*1
Operation
6
49
Advertisement
Table of Contents
