AMX Modero ViewPoint MVP-8400 Operation/Reference Manual page 69

Features on the Protected Setup page include:
Protected Setup Page
Navigation Buttons:
Back:
WiFi/Wired icon:
Connection Status icon:
Device Number:
Options:
System Recovery:
System Recovery (Cont.):
Reboot Panel:
Docking Station:
MVP Modero ViewPoint Touch Panels
The buttons along on the left side of the page provide access to secondary Pro-
tected Setup pages (see following sections).
Saves all changes and returns to the previous page.
The icon to the left of the Connection Status Icon displays whether the current
connection to the Master is Wireless (image of a radio antenna) or Wired
(image of three networked computers).
The icon in the upper-right corner of each Setup page shows online/offline state
of the panel to the master.
• Bright red - disconnected
• Bright green - connected. Blinks when a blink message is received to dark
green every 5 seconds for half a second then go back to bright green.
• Bright yellow - panel missed a blink message from the master. It will remain
yellow for 3 missed blink messages and then turn red. It will return to green
when a blink message is received.
Note: a Lock appears on the icon if the panel is connected to a secured NetLinx
Master.
Opens a keypad used to view/set the device number of the panel.
• Function Show - toggles the display of the channel port, channel code, level
port and level code on all touch panel buttons (see FIG. 48).
• Page Tracking - toggles the page tracking function. When enabled, the panel
reports page data to the NetLinx Master.
• Telnet - enables/disables the panel's telnet server (to allow direct telnet
communication to the panel).
• Front Button Setup Access - activates the two lower buttons on the front of
the panel for accessing the Setup and Calibration pages (see FIG. 42 on
page 51). The default setting is On.
- Press and hold these buttons for 3 seconds to access the Setup page.
- Press and hold these buttons for 6 seconds to access the Calibration page.
• Use the Security button to toggle between three security settings: Standard
Security, Secure, and DoD. Refer to the Security Settings section on page 57
for very important information on using this feature.
• Reset System Settings - deletes all of the current configuration parameters
on the panel (including IP Addresses, Device Number assignments,
Passwords, and other presets). This option invokes a Confirmation dialog,
prompting you to confirm your selection before resetting the panel.
• Remove User Pages - allows you remove all TPD4 touch panel pages
currently on the panel, including the pre-installed AMX Demo pages. This
option invokes a Confirmation dialog, prompting you to confirm your selection
before removing the panel pages.
Note that the YES button on the Confirmation dialog is disabled for 5 seconds
as additional protection against accidentally resetting the panel or removing
the panel pages.
Pressing this button causes the panel to reboot after saving any changes.
• Dock Status - illuminates when the MVP is docked and communicating with
the Docking Station.
• Undock Panel - forces the docking station to release the MVP without
requiring a User Access username or password.
• Disable Docking Station LED - disables the display of the LEDs on the
docking station.
Setup Pages
55