Oce 7050 User Manual page 17

Notice the direction arrow near the roll feeding knob. Turn the knob in the
6
direction of the arrow, to feed out some copy material (see figure 8).
If you turn the knob in the wrong direction, the copy material can slip
Note:
out of the feeder (see 'Inserting a new copy material roll' on page 24).
[8] Turning the roll feeding knob.
Hold the copy material in the middle, and pull out material until the copy
7
length counter shows the same length as the original, as shown by the display
on the operating panel.
Minimum length of the copy material is 420 mm.
Note:
You can turn the roll feeding knob to adjust the length of the copy
Note:
material.
Hold the copy material with one hand, and move the cutter with your other
8
hand entirely to the left or right side to cut the material.
Feed the copy material into the copy feed table in accordance with the
9
guidelines. Start feeding the cutting edge and feed in line with the original.
(see figure 9 on page 18). The copy will now be made.
The copy material is aligned in the nip of the rollers. By inserting the
Note:
material with an amount of slack, the leading edge is aligned in the nip. A delay
between insertion of the material and the start of the transport ensures proper
alignment.
Copy jobs 17