Oce 7050 User Manual page 14

Feed the original centrally and face down into the original feed table in
3
accordance with the guidelines (see figure 4).
[4] Feeding an original
The original is aligned in the nip of the rollers. By inserting the material
Note:
with an amount of slack, the leading edge is aligned in the nip. A delay between
insertion of the material and the start of the transport ensures proper
alignment.
The original is transported to the rear of the machine.
Attention:
circumstances the copier can pull the original in.
Minimum length of the copy material is 420 mm.
Note:
Océ 7051 only: After the job is completed the copy counter will be set to 0. By
4
pressing the '+' button, the original will be transported to the rear of the
machine in order to make a next copy, and the counter will be increased to 1.
By pulling out the original the counter will be set to 1.
Changing the set amount can be done at all times.
Note:
When you make a mistake you can press the correction button to correct the
copy quantity.
After 2 minutes the operator panel returns to the ready mode. When you
Note:
wait more than 2 minutes you have to re-feed your original.
14 Océ 7050/7051 User Manual
Strongly curled originals have to be fed in carefully. In certain