Bed Locking Pin; Rear Shock Absorbers - Husqvarna HUV 4214 User Manual

BED LOCKING PIN

See General Warnings on page 10.
While holding the bed in the fully raised position, remove the bed locking pin from its stowed position under the bed
and insert it into the bed locking pin holes in the bed hinge plates (Figure 9, Page 25). Prior to lowering the bed,
remove the bed locking pin from the bed locking pin holes in the bed hinge plates and return it to its stowed position
under the bed. See following DANGER and WARNING.
DANGER
• Use caution when working under bed. Be sure bed is secured with locking pin. Otherwise the bed
could fall, resulting in severe personal injury or death.
WARNING
• For vehicles with cargo beds, remove all cargo before raising the bed or servicing the vehicle. If the
vehicle is equipped with a locking pin, ensure that it is securely installed. Do not lower bed until all
persons are clear of cargo bed area. Keep hands clear of all crush areas. Do not drop cargo bed;
lower gently and keep entire body clear. Failure to heed this warning could result in severe personal
injury or death.
1. Locking Pin 2. Bed Locking Pin Holes
k-00221
Figure 9 Bed Locking Pin

REAR SHOCK ABSORBERS

The vehicle arrives from the factory with the rear coil-over shocks pre-adjusted for optimum vehicle performance.
CAUTION
• Do not adjust the rear shock absorbers. Damage to the shock absorbers could result.
2009 HUV 4214, HUV 4414, andHUV 4414-XP Owner's Manual
Bed Locking Pin
Page 25