Husqvarna HUV 4214 User Manual page 16

Controls and Indicators
KEY SWITCH
The key switch (7) is mounted on the instrument panel to the right of the steering column (Figure 5). It has three
positions: OFF, ON, and START.
To start the vehicle, place the Forward/Reverse handle in the NEUTRAL position and turn the key to the START
position, and hold it there until the engine starts. Activate the choke (14) as necessary. If the engine does not start after
10-15 seconds, release the key and repeat the procedure. Once the engine starts, release the key and it will return to
the ON position. The engine will idle in neutral. The engine will continue to idle until the key is turned to the OFF
position. See following WARNING, CAUTION, and NOTE.
WARNING
• Moving parts! Keep clear of the engine compartment while the engine is running.
CAUTION
• Do not shift the Forward/Reverse handle while the accelerator pedal is pressed. Shift the handle only
when the vehicle is at a complete stop and the engine is at idle. Failure to heed this caution could
result in damage to the transmission.
Page 14 2009 HUV 4214, HUV 4414, andHUV 4414-XP Owner's Manual
829
Figure 5 Instrument Panel