Bed Latch - Husqvarna HUV4210-G Owner's Manual

Bed Latch

4. Make sure wheels are turned in desired direction.
5. Turn the key all the way to the START position and hold, activating the choke as necessary, until the engine
is running smoothly. The engine will idle in neutral.
6. Select direction by placing the Forward/Reverse handle in desired position (F = forward or R = reverse). A buzzer
will sound as a warning when the Forward/Reverse handle is in the REVERSE position.
7. Slowly press accelerator pedal. The park brake will release automatically and the vehicle will start to move. As
the accelerator pedal is pressed, speed will increase until full speed is reached. See following WARNING.
WARNING
• Operator must control speed when going downhill.
• Do not shift the vehicle out of forward while going downhill. If you do, you will not be able to shift
into reverse or back into forward until stopped.
• Press the brake pedal as necessary and partially press the accelerator when descending a hill. With
the accelerator pedal partially pressed, the governor will cause the engine to assist the brakes in
controlling downhill speed.
STOPPING THE VEHICLE
WARNING
• Driving through water may affect the brakes. After driving through water, check effectiveness of the
brakes by gently pressing the brake pedal. If the vehicle does not slow down at the normal rate,
continue to press the brake pedal until the brakes dry out and normal performance returns.
CAUTION
• When stopped on a hill, use the brake pedal to hold your position. Do not use the accelerator pedal
to hold position.
To stop the vehicle, release the accelerator pedal and press the brake pedal with your right foot until the vehicle
comes to a complete stop.
PARKING AND LEAVING THE VEHICLE
1. After stopping the vehicle, firmly press the park brake pedal until it locks. This will prevent the vehicle from rolling.
2. Turn the key switch to the OFF position and place the Forward/Reverse handle or switch in the NEUTRAL
position. Remove the key when the vehicle is not in use.
– Electric vehicles only: When the Tow/Run switch is in the RUN position (with the Forward/Reverse switch or
key switch in any position), the walk-away braking function will prevent the vehicle from rolling at more than 1
to 3 mph (1.5 to 4.8 km/h) unless the accelerator is pressed. This prevents the possibility of a parked vehicle
(with the park brake disengaged) rolling away too fast to be overtaken on foot.
– Gasoline vehicles only: Turn the fuel shut-off valve to the closed (OFF) position when the vehicle is not in use.
BED LATCH
See General Warnings on page 10.
Page 24 2009 HUV4210 Owner's Manual