Checklist - Bryant 352AAV Installation, Start-Up, And Operating Instructions Manual

1. Put away tools and instruments. Clean up debris.
2. Check SW-1 through SW-3 after completing installation to
ensure desired settings for thermostat type (SW-1) and
blower-OFF delay (SW-2 and SW-3).
3. Verify flame rollout manual reset switch has continuity.
4. Verify that blower and outer doors are properly installed.
CHECKLIST—DIRECT VENT (2-PIPE) INSTALLATION
LOAD CALCULATION
____________ Heating Load (Btuh)
____________ Cooling Load (Btuh)
____________ Furnace Model Selection
COMBUSTION AIR AND VENT PIPING
Termination Location
____________ Roof or Sidewall
____________ Termination Kit --- 2 Pipe or Concentric
____________ Combustion-Air Pipe Length
____________ Combustion-Air Pipe Elbow Quantity
____________ Vent Pipe Length
____________ Vent Pipe Elbow Quantity
____________ Pipe Diameter Determined from Sizing Table
____________ Pipe Sloped To Furnace
Pipe Insulation
____________ Over Ceilings ________
____________ Low-Ambient Exposed Pipes

CHECKLIST

5. Cycle test furnace with room thermostat.
6. Check operation of accessories per manufacturer's
instructions.
7. Review User's Guide with owner.
8. Leave literature packet near furnace.
Condensate Drain
____________
____________
____________
____________
____________
CHECKLIST - - START-UP
____________
____________
Thermostat Anticipator
____________
____________
Safety Controls Check Operation
____________
____________
61
Unit Level or Pitched Forward
Internal Tubing Connections Free of
Kinks and Traps
External Drain Connection
Leak Tight and Sloped
Condensate Trap Primed before Start-Up
Heat Tape Installed if Required
Gas Input Rate
(Set Within 2 percent of Rating Plate)
Temperature Rise Adjusted
Anticipator Setting Adjusted or
Cycle Rate (3 Cycles per Hr) Selected
Primary Limit
Pressure Switch