Bryant 352AAV Installation, Start-Up, And Operating Instructions Manual page 62

CHECKLIST - - NON DIRECT VENT (1-PIPE) INSTALLATION
LOAD CALCULATION
____________ Heating Load (Btuh)
____________ Cooling Load (Btuh)
____________ Furnace Model Selection
VENT PIPING
Termination Location
____________ Roof or Sidewall
____________ Vent Pipe Length
____________ Vent Pipe Elbow Quantity
____________ Pipe Diameter Determined from Sizing Table
____________ Pipe Sloped To Furnace
Pipe Insulation
____________ Over Ceilings
____________ Low-Ambient Exposed Pipes
E2008 Bryant Heating & Cooling Systems D 7310 W. Morris St. D Indianapolis, IN 46231
Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations.
Condensate Drain
____________ Unit Level or Pitched Forward
____________ Internal Tubing Connections
Free of Kinks and Traps
____________ External Drain Connection Leak Tight and
Sloped
____________ Condensate Trap Primed before Start-Up
____________ Heat Tape Installed if Required
CHECKLIST—START-UP
____________ Gas Input Rate
(Set Within 2 percent of Rating Plate)
____________ Temperature Rise Adjusted
Thermostat Anticipator
____________ Anticipator Setting Adjusted or
____________ Cycle Rate (3 Cycles per Hr) Selected
Safety Controls Check Operation
____________ Primary Limit
____________ Pressure Switch
Printed in U.S.A. Edition Date: 12/08
62
Catalog No. II352A --- 60 --- 2
Replaces: II352A---60---1