Troubleshooting - Procedures - Jacuzzi J-460 Owner's Manual

15.0 Troubleshooting - Procedures

In the unlikely event your spa is not working the way you believe it
should, please first review all the installation and operating instructions in
this manual and check the message on the panel display; second, if you
are still not satisfied it is working properly, please follow the appropriate
troubleshooting instructions.
PROBLEM
NONE OF THE
COMPONENTS
OPERATE (i.e.
pump light)
PUMP DOES
NOT OPERATE
AND ICON DOES
Pump Priming Instructions:
1. Turn off power to the spa.
2. Remove the handle from the massage selector supplied by the
pump you are priming.
3. Loosen the massage selector's cap slightly (counterclockwise),
listening for the air to seep out.
4. Tighten the cap finger-tight, replace the handle and turn the hot
tub's power back on.
PROCEDURE
Check the control panel lights.
1. If there are letters or symbols displayed on the
screen, refer to the previous section to deter-
mine the meaning and action required.
2. If nothing appears on the screen:
A. Check the household circuit breaker
B. Contact you dealer or authorized service
center
Depress "JETS" button.
1. If no sound is detected or if a "buzzing" sound
AND ICON DOES is detected, turn off power
to the spa and contact your dealer or service
center.
2. If motor operates but no water flows to jets:
A. Pump may not be properly primed. See
instructions below.
B. Contact dealer or authorized service center.
Page 51