CYBEX 600T Service Manual page 46

4. Remove the display cable.
A. Locate the connector that goes from the upright into the handlebar. If needed
gently use needle nose pliers to pull the cable out of the handlebar. Unplug the
connector and pull the upper display cable out of the handlebar. See Figure 17.
5. Replace the upper display cable.
A. Locate the handlebar entry hole. It is hidden underneath a bracket near the bottom
left of the handlebar.
B. Twist about 8" (20 cm) of the display cable. Twisting will help to prevent it from
getting stuck when you push it through the handlebar tube.
C. Put the connector into the entry hole and push the twisted part through. Bend the
remaining cable in half as you feed it into the tube.
D. When you see the connector appear at the exit hole on the handlebar, gently grab
the connector with a pair of needle nose pliers and pull it out of the exit hole.
E. Plug the connector into the display board.
Lower Display Cable
NOTE: Before removing the lower display cable begin with the "Upper Display Cable"
6. Remove the motor cover.
A. Remove the two Phillips head screws that fasten the motor cover to the frame.
B. Lift the cover from the front and remove it from the treadmill. Set the cover and
screws aside. See Figure 1.
7. Disconnect lower display cable.
A. Locate and unplug the cable connector that goes from lower control board into the
left upright.
B. If the lower cable is still connected to the upper cable at the handlebar junction
remove the junction covers as described in the "Upper Display Cable" procedure
above. Open the retaining clip and remove the display cable from it. Then pull the
old cable out of the upright tube and discard it.
8. Replace the lower display cable.
A. Locate the entry hole on the left upright near the top mounting bracket. See
Figure 17.
B. Twist about 12" (30 cm) of the display cable. Twisting will help to prevent it from
getting stuck when you push it through the upright tube.
Page 5-24
Cybex 600T Treadmill Service Manual
procedure above.