CYBEX 600T Service Manual page 18

C. Remove the other side rail and set aside.
3. Check belt condition.
A. Run your hand under the belt on the top of the deck surface. If you notice any
excessive ridges, furrowing or cracks
the surface may have worn down to a point where it could start to cause excessive
wear to the undersurface of the running belt. For running belt replacement
information
4. Replace the side rails and plastic end caps.
A. Slide the two side rails back on being sure to catch the rail guides.
B. Attach the plastic end caps with the Phillips screwdriver.
NOTE: For running belt replacement
! CAUTION: Do not use
Rotating the Deck - You may rotate the deck but do not flip the deck. The wax surface
is only on the top side of the deck. Do not rotate the belt. The belt
Running Belt and Running Deck
Belt and Deck Surfaces - To minimize the effect of friction between the deck and the
running belt, Cybex recommends cleaning the underside of the running belt and the top
on the running deck surface by wiping them with a clean, dry towel. This simple
procedure should be done approximately four times a year to prevent premature wear of
the deck, running belt and the drive motor system.
Page 3-4
Cybex 600T Treadmill Service Manual
see Running Belt
Replacement chapter.
a
running belt made for
belts are specific for each treadmill and may be torn up or cause
excessive current and damage the electronics if used in combination
with another deck.
in the deck or
in the Removal and Replacement chapter.
information see Running Belt in the Removal and
a
different model treadmill. The
in the Removal and Replacement chapter.
if the deck feels very rough,
is directional. See