Figure 16
Heart Rate Board
Tools Required
• Phillips head screwdriver
NOTE: This procedure will cover the heart rate board and handset board.
1. Turn the power off.
A. Turn the main power switch in the front panel to the off (0) position.
B. Unplug the treadmill from the power outlet.
2. Remove the console back.
A. Remove the eleven Phillips head screws on the console back. Leave the top screw
which holds the accessory holder in place. The top screw will keep the accessory
holder in place on the console back. Set the console back and screws aside. See
Figure 15.
Page 5-20
Cybex 600T Treadmill Service Manual
E-Stop
CSAFE
Port
Port
Contact Heart
Polar
Rate Port
Port
Polar
Front Sensor
Board
Plate