CYBEX 600T Service Manual page 24

Figure 2
3. Remove the plastic end caps and side rails.
A. Remove the Phillips head screws that fasten each of the plastic end caps in place
and set aside. See Figure 2.
B. Grasp the side rail and firmly slide
C. Remove the other side rail and set aside.
4. Remove the rear roller.
A. Loosen and remove the two rear roller bolts. See Figure 3. Loosen each bolt
evenly, making sure not to loosen either bolt too many turns before
other bolt. Remove the bolts, springs, nuts and washers and set them aside.
B. Lift one side of the
5. Loosen the deck.
A. Remove
the deck in
Page 5-2
Cybex 600T Treadmill Service Manual
rear roller and slide it out of the running belt.
Figure 3
the ten bolts, eighteen washers and two belt retaining washers which hold
place. Set these aside. See Figure
End Caps
Phillips Head
it out toward the front of the treadmill.
Rear
Roller
Rear
Roller Bolts
/
4.
moving to the