Register A Headset To An At&T Dect Cordless Telephone Base - AT&T TL7800 User Manual

Getting started
Adding and registering headsets
Register a headset to an AT&T DECT cordless telephone base
1. Make sure the battery is properly installed
in the headset (see page 6). The
the headset flashes slowly in red and blue to
indicate the headset is not registered.
2. Place the headset in the headset charger and
allow it to charge for at least one hour before
beginning registration.
3. Remove the headset from the charger.
4. On the telephone base of the cordless phone,
press and hold
the red IN USE light turns on (about four seconds) and then
release the button.
If your telephone base has no
/HANDSET LOCATOR button:
Press and hold the HOLD button until the
screen displays Registering... Please wait,
then release the button.
-OR-
Press and hold the
the screen displays Registering handset...,
then release the button.
5. Place the headset back to the charger.
The light flashes quickly in red and blue.
/HANDSET LOCATOR until
LOCATOR button until
13
light on