Getting started
Adding and registering headsets
Register a headset to an AT&T DECT cordless telephone base
(cont.)
It takes about 60 seconds to complete the registration process.
The
light turns red when the headset is registered but not fully
charged, or turns blue when it is registered and fully charged.
To verify the registration, press the
button on the headset and
check for a dial tone. If the registration fails, you hear the voice
prompt "Not registered" and the
light on the headset flashes
slowly in red and blue.
To reset the headset, remove it from the headset charger and try
the registration process again.
NOTE: The button used for registration on your cordless telephone system may
be different. Refer to your telephone user's manual for detailed information.
14