Table of Contents
Advertisement
Getting started
Adding and registering headsets
Register a headset to an AT&T DECT cordless telephone base
1.
Make sure the battery is properly installed
in the headset (see page 6). The
the headset flashes slowly in red and blue to
indicate the headset is not registered.
2.
Place the headset in the headset charger and
allow it to charge for at least one hour before
beginning registration.
3.
Remove the headset from the charger.
4.
On the telephone base of the cordless phone,
press and hold
FIND HS until the red IN USE light turns on (about four
seconds) and then release the button.
If your telephone base has no
FIND HS button:
Press and hold the HOLD button until the screen displays
Registering... Please wait, then release the button.
-OR-
Press and hold the
displays Registering handset..., then release the button.
5.
Place the headset back to the charger. The
quickly in red and blue.
/HANDSET LOCATOR or
/LOCATOR button until the screen
10
light on
/HANDSET LOCATOR or
light flashes
Advertisement
Table of Contents
