Figure 4.41 Installing The Lcd Hinge Assembly; Installing The Lcd Module - Toshiba Satellite Maintenance Manual

Installing the LCD Module

Install the inverter board according to the following procedures.
1. Connect the LVDS cable to the LCD panel connector.
2. Seat the LCD hinges in the correct position beside the LCD panel and secure it with six
M2x3 screws according to the sequence indicated in Figure 4. 41.
3
3. Seat the LCD module in the correct position in the LCD cover assembly. Secure it to the
LCD cover assembly with six M2x4 screws.
4. Connect the cable to camera module.
CAUTION: Ensure the correct routing position of the LVDS cable so as not to compromise it
during installation of the LCD module. Check the routing carefully and ensure that the LVDS
cable is not pinched during installation.
Satellite/Satellite PRO T230D Maintenance Manual
2
1

Figure 4.41 Installing the LCD Hinge Assembly

4 Replacement Procedures
3
2
1
4-55