4 Replacement Procedures
2. Turn the logic upper assembly upside down. Remove one M2x4 screw and remove the
power board from the logic upper assembly.
Installing the Power Board
Install the Power Board according to the following procedures.
1. Seat the power board in the correct position on the logic upper assembly and secure it
with one M2x4 screw.
2. Insert the power board FFC into the slot on the logic upper assembly. Adhere the FFC to
the front of the logic upper assembly as shown in Figure 4.16.
Satellite/Satellite PRO T230D Maintenance Manual
M2×4*1
Figure 4.17 Removing the power board
4-26