2. Remove the two M2x3 screws and remove the HDD by pulling the tab attached to the
HDD.
NOTE: Do not disassemble the HDD pack when it is working normally. Disassemble or
replace the HDD pack only if it fails.
3. Place the HDD pack on a flat surface such as a desk.
4. Remove the four M3x3 screws and separate the bracket from the HDD.
2
M3×3*4
Satellite/Satellite PRO T230D Maintenance Manual
Figure 4.3 Removing the HDD
1
Figure 4.4 Removing the HDD bracket
4 Replacement Procedures
M2×3*2
3
4
4-11