4 Replacement Procedures
4.16
LED Board
Removing the LED Board
Remove the LED Board according to the following procedures and Figure 4.27.
1. Disconnect the LED cable from the motherboard and pull it out of the routing channel.
2. Pry the fixing ribs outward as indicated in Figure 4.27 and remove the LED board from the
logic lower assembly.
Installing the LED Board
Install the LED Board according to the following procedures.
1. Seat the LED board in the correct position on the logic lower assembly. Make sure that it is
secured by the fixing ribs.
2. Route the LED cable in the routing channel and connect it to the motherboard.
Satellite/Satellite PRO T230D Maintenance Manual
Figure 4.27 Removing the LED Board
4-40