Footrests; Armrests - Invacare Action Vertic User Manual

2.1.5. Footrest (height, angle and depth adjustment of the one-
piece footplate) (photo 6)
- Remove the two screws (A & B) sideways (4 mm hexagonal
key), adjust to the desired height, reposition the screws in the
preset holes and firmly tighten sideways.
- For angle adjustment, loosen screws (A & B), adjust to the
desired angle by positioning screw (B) in one of the 3 threads
and firmly re-tighten the screws (A & B) sideways.
- Remove the two screws (A & B) sideways to position the
one-piece footplate forwards or backwards, reposition the
screws in the preset holes and tighten firmly.
B
A
6
2.1.6.Armrests (height adjustment and foam removing)
(photo 7)
- Loosen the two screws (A) (5 mm hexagonal key) of each
armrest tube support to make their sliding on the backrest
tubes easier, slide the armrest tube supports upwards or
downwards based upon the user's morphology.
Firmly retighten the two fastening screws (A) sideways.
- The foam tubular coating of the armrest tube is subject to
wear.To replace it, remove it and perfectly clean the tube, coat
the tube and the inside of the new tubular foam coating with
very soapy water, slide the foam coating forwards on the tube
to its front end.
!
Wait at least for 24 hours for the soapy water to be
completely evaporated before using your stand up wheelchair
again.
A
7
19