Brady TLS2200 User Manual page 39

5. At the prompt "No. of Copies?", enter the number of times you want the active list to
print (up to 250) and press <Enter>.
This is the number of copies of each label within the list. If two copies are requested, the labels
will print in this order [1,1,2,2,3,3...]. You cannot print multiple copies of the list in this order
[1,2,3,1,2,3...] from the Print option.
Note: If a list is activated but no legends are recalled, the Print option goes directly to
the "No. of Copies?" prompt.
Although a list is typically printed on the part it was created for, you can print the list using
any part that has a printable area greater than or equal to the part for which the list was
originally created in both the X and Y dimensions. However, if you try to print on a smaller
label, the error message "Invalid Function" will display on the Text Editor screen.
Editing a List
Editing a list involves deleting legends from a list and changing characters in a legend already
in a saved list.
There are two ways to edit an active list:
1. If you have the correct part (the part the list was originally created for) installed in the
printer, you can recall legends from the active list and then edit them the same way you
would edit a non-list legend.
2. If you do not have the correct part (or do not have any part) installed in the printer, you
can still edit a list through Edit mode. Edit mode is explained later in this section.
To edit a list:
1. Select the list that you want to edit. Refer to Selecting a List earlier in this section for
instructions.
You cannot select a list unless the correct part (the part the list was created for) is loaded in the
printer. If you try to select a list without the correct part loaded in the printer, or no part is
loaded in the printer, this error message will display on the Text Editor screen:
The part your list
was created for
This message will also display if you are trying to save a legend to an active list, and the
wrong part (a part other than the part the list was created for), or no part, is loaded in the
printer.
30
Wrong Part! Use
PTL-XX-XXX
This message will only display
if the Edit mode is off.
TLS2200
™
Thermal Transfer Printer User Manual