Setting The Scan Resume Condition; Setting The Scan Resume Delay - Radio Shack HTX-212 Owner's Manual

19-1125.fm Page 22 Tuesday, August 3, 1999 9:47 AM

Setting the Scan Resume Condition

When you scan VFO frequencies or frequencies you stored in memory,
the HTX-212 stops at any signal strong enough to break squelch. The
HTX-212 is preset to ti, meaning it resumes scanning in 10 seconds,
even if the signal continues.
Follow these steps to change the scan resume condition.
1. Press VFO.
2. Hold F for at least 1 second. FUNC flashes.
3. Press MR. The HTX-212 displays SC and the current option.
4. Rotate TUNE, or press UP or DOWN on the microphone, to select
5. Press MR to save the setting.

Setting the Scan Resume Delay

When you set the scan resume condition to cr (carrier), the HTX-212
resumes scanning after the carrier drops. The scan resume delay option
lets you set the HTX-212 to pause before resuming so you can hear any
reply. The factory default for this option is 2 seconds.
Follow these steps to change the scan resume delay.
1. Press VFO.
2. Hold F for at least 1 second. FUNC flashes.
3. Press MR.
4. Repeatedly press s until the HTX-212 displays Sd and the current
5. Rotate TUNE, or press UP or DOWN on the microphone, to select
6. Press MR to save the setting.
22
ti Resumes scanning in 10 seconds
cr Resumes scanning after the carrier drops and the scan
resume delay expires
SE Does not resume scanning
the desired option.
scan resume delay (0.5, 1, 2, or 4 seconds).
the desired scan resume delay.