Setting The Frequency Step; Setting The Scan Options; Storing Scan Skip Frequencies - Radio Shack HTX-212 Owner's Manual

19-1125.fm Page 21 Tuesday, August 3, 1999 9:47 AM

SETTING THE FREQUENCY STEP

The factory default frequency step is 20 kHz. Each time you rotate TUNE
one click, or press UP or DOWN on the microphone, the frequency
changes by 20 kHz. When scanning, the HTX-212 scans up or down 20
kHz per step.
Follow these steps to change the frequency step.
1. Press VFO.
2. Press F then STEP. The HTX-212 displays St and the current fre-
3. Rotate TUNE, or press UP or DOWN on the microphone, to select
4. Press MHz to save the setting.

SETTING THE SCAN OPTIONS

Storing Scan Skip Frequencies

You can store up to five frequencies for your HTX-212 to skip when scan-
ning. This lets you prevent the HTX-212 from stopping on beacon or
packet repeater frequencies.
1. Press VFO.
2. Hold F for at least 1 second. FUNC flashes.
3. Press MR. The HTX-212 displays SC and the current scan resume
4. Repeatedly press s until the HTX-212 displays S1 and the first scan
5. Select the first scan skip frequency by rotating TUNE, pressing UP
6. Press s for the next scan skip memory—S2, S3, S4, or S5.
7. Repeat Steps 5 and 6 for each scan skip frequency.
8. Press MR to save the setting.
quency step.
the desired frequency step (5, 10, 12.5, 20, 25, 50, or 100 kHz).
setting.
skip frequency (or –––.––– if no frequency is stored).
or DOWN on the microphone, or directly entering the last five digits
of the frequency.
21