19-1125.fm Page 7 Tuesday, August 3, 1999 9:47 AM
MOUNTING THE HTX-212 IN A VEHICLE
When you select a mounting location for the HTX-212, be sure:
•
•
•
•
Cautions:
•
•
•
Use the supplied screws, metal washers, bracket, rubber washers, and
mounting knobs, as shown, to mount the transceiver.
You can easily reach it
No wires or cables will interfere with the vehicle's operation
It is not directly in front of heating vents
All wires will reach their connection points
Install the transceiver only in a vehicle that has a 12-volt, nega-
tive-ground electrical system.
To avoid damaging your vehicle's electronic systems, contact
your vehicle's manufacturer before you install the HTX-212 to find
out about the proper transceiver mounting locations, antenna
locations, and power and antenna cable routing guidelines.
Do not apply power to the transceiver until after you properly
mount and connect an antenna.
7