JVC HX-Z30 Service Manual page 5

3.1.3 Removing the front panel assembly
(See Fig.6~9)
• Prior to performing the following procedure, remove the metal
cover and the CD changer mechanism assembly.
(1) Disconnect the card wires from connector
CN870 on the main board on the right side of the body.
(2) Disconnect the wire from connector
board.
(3) Cut the band.
(4) Disconnect the wire from connector
board on the left side of the body and remove the band
fixing the wire.
(5) Disconnect the ground wire extending from phones board
from bottom chassis.
(6) Remove the three screws D attaching the front panel
assembly at the bottom of the body.
(7) Release the two joints a on the lower left and right sides of
the front panel assembly using a screwdriver, and remove
the front panel assembly toward the front.
REFERENCE:
Front panel need to be tilt a little bit as release from bottom
chassis.
Front panel assembly
a
1-8 (No.MB043)
CN44
CN701 on the bridge
CN231 on the primary
Bridge board
CN701
Main board
CN44
CN870
Fig.6
and
Primary board
Primary board
CN231
D
Front panel assembly
Band
a
CN231
Fig.7
Band
Ground wire
Front panel assembly
Fig.8
Front panel aeembly
Fig.9